Tailor-made for aeromodelers & FPV pilots Meet the black sheep of the Dronetag family. Dronetag BS is a no-fluff bare Direct / Broadcast Remote ID minimum for aeromodelers, FPV pilots, and hobbyists to get them RID-ready. Compliant with EU & US standards, FAA approved. Drone RID for FPV, models & hobby planes Pretty upset about Remote ID requirements for recreational pilots? We get ya. New rules in EU & US regions force Direct / Broadcast Remote Identification (RID) to nearly all pilots. Dronetag BS is here for aeromodelers, FPV pilots and recreational pilots, making their drones compliant without sacrificing limited payload or losing hobby. Bare Minimum for Skilled Drone DIYers This 1-gram device equips your drone with Bluetooth Direct / Broadcast RID. However, its installation requires external antennas, one for Bluetooth and one for GNSS positioning. Plus, a power source because Dronetag BS comes without any battery. Can you install it on your ultralight FPV drone? Or a custom-built beauty? If yes, go for BS and get compliant in no time! BS is so flexible that you can use it regardless of which drone you use.If you own DJI or any other branded off-the-shelf drone with sealed-off hardware, the better option for you is Dronetag Beacon. You can easily stick it on the drone without pulling out any wires. Beacon is a fully independent device that comes with a built-in battery, accelerometer, antennas and many other features. What is more, you can quickly swap it between all your drones! All It Takes to Become RID-Compliant First thing first. Dronetag BS weighs 1.3 grams (0.046 oz), including antennas, so your aircraft should be able to handle this extra payload. Next, you need U.FL compatible antennas, 2.4 GHz for Bluetooth and 1.575 GHz for GNSS. And lastly, power it up with a 3 or 4-pin power input cable (3.3V-17V). Dronetag BS is equipped with flash memory to store a few hours of flight data for later export and a supercapacitor to maintain a GPS fix for 7 minutes in case you need to power-cycle your aircraft. Dronetag BS is the best Remote ID solution for FPV pilots, aeromodelers & recreational pilots. BS offers affordable Remote ID capability as defined by FAA and EASA. It is the smallest and lightest RID solution making it easier than ever for pilots to comply with regulations while enjoying their hobby. Package contains: 1× Dronetag BS 1x 3D printed Enclosure with battery slot 1x Li-Po battery 1x USB-C battery charger 1x External GNSS Wire Antenna (U.FL) 1x External Bluetooth Wire Antenna (U.FL) 1x Shrink Tube 1x JST SH 3-pin to Open Wire Cable 1x JST SH 4-pin to Open Wire Cable
