The Dual Voltra Plate is a bolt-on adapter designed specifically for the Rogue T-Bar Row Offset Drop Mount. It allows lifters to mount two VOLTRA I units concurrently for doubled resistance and training versatility. Install guide: Dual Voltra Plate Installation Instructions — torque, flat-mating checks, and Rogue base-plate hardware ID. Installation is simple and direct: Remove the existing DIY Dock from your Rogue T-Bar Row Offset Drop Mount. Install the Dual Voltra Plate in its place using the included Voltra Mounts hardware (see Specs and the install guide for fastener details). Install hardware included — see Specs. Construction: Precision laser cut from .313" thick A36 steel for maximum strength and durability. Once installed, this sturdy plate gives you the option to use two VOLTRA I units at the same time. Maximum resistance equals the combined total of both VOLTRA I units. Note on Bolt Positioning: In some cases, the button head bolt may touch or rest on the floor when no tension is applied to the mount. This is somewhat dependent on the Chafe Pad fitment of the Deep Drop Mount itself and does not cause any issue with the use or function of the Dual Voltra Plate. Important: Doubler plates are not approved for installation on the Dual Voltra Plate. Product Contents: This listing is for the Dual Voltra Plate (Adapter Plate) only. It does not include the VOLTRA I units, Rogue T-Bar Row Offset Drop Mount, Rogue stand, mag pin, lifting eye, or DIY Dock. Built for serious lifters who want maximum loading capability on their Rogue T-Bar Row setup. Proudly made in the USA by Voltra Mounts.
