The Easy Change Riser System allows you to customize the saddle panel for your optimal clearance and balance. The risers fit in a velcro pocket in between the tree and the cushion panel and for up to 16mm of lift. This system is convenient, quick, and reversible. Up to 16 mm of lift Four different kinds of risers Reversible Three different sets Quick installation There are four different variations of risers (Front, Center Rear, and Rear Tapered). The front risers come in Pony size (4 or 8 mm) or standard size (4, 8, 12, or 16 mm). The centerpieces come in only 4 and 8 mm. The rear come in Pony size (4 or 8 mm) or standard (4, 8, 12, or 16 mm). The rear tapered riser comes in only one standard size. There are three different packs that these risers come in. The first is the Standard pack which includes 4 front risers (4, 8, 12, 16 mm), 2 center risers (4 and 8 mm), and 4 rear risers (4, 8, 12, 16 mm). Then there is the Standard Starter pack which has 2 front, center, and rear risers (all 4 and 8 mm). Finally, there is the Pony/Jump Pack which has 2 pony sized front, center, and back risers. This pack is the only one which fits pony and jump saddles. We recommend purchasing a set of the risers but if a specific piece is needed it can be ordered individually. When you purchase a set you are receiving a $17 piece for only $10. Each set comes with an instruction manual and an Easy Change locating tool necessary for internal adjustments. Installation First, you may need a long-handled Philips Head number 3 screwdriver, your Easy Change Locating Tool, and your Easy Change Riser Kit Instructions. Secure the cantle area of the saddle between a flat surface and your knees, with the saddle panel facing away from you (against the flat surface). Your saddle should now be secure and you should have both of your hands-free. Now… Remove screws at head of saddle Untuck Velcro tab and you should see gullet plate Uncover inside of saddle from front panel Undo the velcro along the length of the panel. Position the risers in the pocket, with logo facing upwards to the tree of the saddle. Align the straight edge of the riser along the edge of the chamber. Fasten the velcro Refit the panel to cover the interior and screw in Double check that everything
