Ember Mug / Cup Replacement Bottom Ring

i3Dprint Australia Verified independent store

→

Fed up with the rubber ring on the bottom of your Ember falling off, stretching out, or losing its stick? You're not alone - it's one of the most common issues Ember owners run int o. The original rings are notorious for going loose over time, and once they've lost their grip, there's not much holding them in place. This is a 3D printed replacement ring designed to give your Ember a new lease on life. Compatible with: Ember Mug 10 oz (295 ml) Ember Mug 14 oz (414 ml) Ember Cup 6 oz (178 ml) Ember Cup 14 oz (414 ml) Printed in TPU for the best result - it replicates the flex and feel of the original - on a textured plate to give a lovely non-slip finish on the bottom as a bonus, which is a step up from the stock ring. Installation is dead simple: Clean the base of your mug Put a couple of drops of superglue on the base Align the tabs and press the ring into place Give it a few minutes to set That's it - your Ember is back in business. Show more