The Evolver Deep Drop Mount is a heavy-duty drop arm designed to extend your Voltra mounting point lower on your rack or rig. Part of the Evolver mount product line, this deep drop gives you a full 6-7/8" of drop from the top side of the upright or crossmember to the bottom side of the drop arm. Key Features & Specifications: Provides a generous 6-7/8" total drop for improved pulling angles and range of motion. Available in 5/8" or 1" rack hole sizes. Ideal for use with Voltra units on power racks, squat racks, and rigs. Most effective when pulling straight from the Voltra. Fitment Note: Please measure your planned installation location carefully before purchasing. You will need at least 7 inches of clear drop from the top of the upright or crossmember to the bottom of the drop arm for this mount to fit properly. Important Usage Guidelines: Approved pulling angle for the Drop Arm is perpendicular to the base plate or up to 10 degrees beyond perpendicular up to the maximum weight of the Voltra. Doubler plates are not approved for installation on the Drop Arm but can be used on the top mounting position if desired. Maximum Approved Load for the Mount Drop Arm is equal to the maximum resistance weight of the Beyond Power Voltra unit. Product Contents: This listing is for the Evolver Deep Drop Mount only. Hardware is included for standard installation. Voltra units, doubler plates, push pins and other accessories are sold separately. Built tough in the USA for serious lifters looking to optimize their Voltra training setup.
