A moulded utensil tray with the compartments set wide — for the tongs, whisks and serving spoons a cutlery slot refuses. Two widths: a 400mm tray and a 550mm tray. Measure the inside of your drawer side to side and pick the one that fits — if you fall between the two, take the smaller, because a tray that is too wide will not go in at all. Then check your depth: the tray is 485mm front to back, which is what a standard 500mm-deep drawer gives you. Allow 57mm clear above the drawer base. If your drawer is a few millimetres short The back rim takes a light trim — enough to clear a drawer that falls just under 485mm, which is the usual reason a tray this size gets sent back. Häfele do not publish a trim allowance, so this is from our own testing rather than a manufacturer specification: it is a light trim to the rim, not a cut-to-size tray, and there is no scope to reduce the width. Measure twice, cut once, and note that a trimmed tray cannot be returned. Product Details Two tray widths: 400mm and 550mm Depth: 485mm — suits drawers 500mm deep; back rim takes a light trim if yours is slightly shallower Height: 57mm Material: vacuum-formed plastic, 2.5mm Three finishes: anthracite, white and silver Open compartments sized for long-handled utensils Width is fixed — order the tray that fits your opening Best For The second drawer in a run, or the free half of a wide one. It sits happily beside a Ninka Cuisio cutlery tray where the cutlery is already handled and the big utensils still need somewhere to go.
