Eye Bolt Back Plate — FIA Compliant, 7/16" UNFAn FIA-compliant seatbelt eyebolt back plate for use with 7/16" UNF harness eyebolts. The back plate distributes the load of the harness anchor point across a larger area of the chassis floor or panel, preventing the eyebolt from pulling through under load. Features a 7/16" UNF welded nut for direct eyebolt engagement. An essential component for any FIA-compliant harness installation where the eyebolt passes through a floor panel or chassis section.Key Specifications Dimensions: 65mm x 65mm x 3mm Thread: 7/16" UNF welded nut Compliance: Meets FIA requirements Application: Seatbelt and harness eyebolt anchor backing plate Why Use a Back Plate?When a harness eyebolt is mounted through a floor panel or chassis section, the load in an accident is concentrated at the eyebolt hole. Without a back plate, this load can cause the eyebolt to pull through the panel, compromising the harness anchor point entirely. A back plate spreads this load across a 65mm x 65mm area, significantly increasing the strength and integrity of the mounting point. Many motorsport regulations, including FIA requirements, mandate the use of a back plate with harness eyebolts.Complete Harness Anchor System Eye Bolt Back Plate (this item) — load-spreading backing plate with 7/16" UNF welded nut 7/16" UNF Seatbelt Eyebolt — threads into the back plate nut from above Safety NoticeHarness mounting points are safety-critical components. Installation should comply with the relevant motorsport regulations (FIA, MSA, or series-specific rules) and be inspected by a qualified person. If in doubt, consult a qualified roll cage builder or motorsport engineer.Why Choose BRT Motorsport?Quality motorsport fasteners and hardware for race and track builds. Shop our full range of harness mounting hardware and motorsport components at BRT Motorsport.
