Ideal for remote control of actuators Each remote control has 4 buttons, 2 buttons per actuator 2 modes, sustaining or latching 10A max per channel The Firgelli Automations 2-4 Channel Remote Control System comes pre-programmed in sustaining mode, this means that the actuator will move for as long as your finger is held on the button. In latching mode you only have to press the button once and the actuator will go all the way to the end. To change the mode, all you have to do is open up the case on the receiver and remove the jumper that connects 2 pins together and place it on just 1 pin, then you need to remove the power to the remote receiver and then apply the power again, this resets the system. To program more remotes you have to press and hold the button on the circuit board, you will have to open the case first. Hold the button for a few seconds until the red LED flashes. Then press any button on each of the remotes you want to program, 1 at a time, so if you have 4 remotes you need to program all the remotes, even if they were already programmed, and just press any one of the 4 buttons on each remote. Then remove the power from the receiver and plug it back in again. Now all remotes should work with the receiver. It is suggested to use a 5 amp fuse to protect the remote system.
