We have 3 top options that finish off your J-series Main Body. The Full Cage Top is secured with 6 M2 screws and the scale dash gets glued to the lower windshield section. This top is a 2 piece and gets screwed together with 4 top side screws that connect the pieces together. The Half Top is secured with 4 M2 screws. The scale dash gets glued to the lower windshield section. This top has provisions for Back Roll Bars and are included. The roll bars also get screwed to the top and main body. The Hard Top is secured with 6 M2 screws and the scale dash gets glued to the lower windshield section. For gluing parts to the body, you can use a CA glue, or my favorite is Shoe Goe or e6000, the rubbery type glue helps with impacts and is also great for magnets. For gluing parts to the body, you can use a CA glue, or my favorite is Shoe Goe or e6000. The rubbery type glue helps with impacts and is also great for Magnets. CarbonFiber colors have a print quality increase, including higher temp and impact resistance. It also provides a textured matte finish, the raw prints can be painted without prep if desired. For normal paint preparation, we recommend starting with 220 Wet Sand with a flexible block, then move to 320 Wet Sand. Use a high fill sandable primer, and wet sand with 400, repeat last step until desired finish is achieved before base coat. When choosing a color and planning to paint, you have options! You can pick the same color as your paint, so scratches will be less visible!Bodies do require prep if planning to paint. For prep we reccomend starting with 220 Wet Sand with a flexible block, then move to 320 Wet Sand. Use a high fill sandable primer, and wet sand with 400, repeat last step until desired finish is achieved. ***All products are made to order. Please check the header on the main page for approximate lead times. Thank you for your support and patience - FlubRC
