Fore/aft offset stick extension bracket

Core Shifters Verified independent store

→

For situations where the height of the stick is fine but more or less rear offset is desired, this bracket may be the answer: 3/8" mounting for Hurst sticks only (other sticks & sh ifters use M8 bolts) Steeda sells a similar "offset handle bracket" #555-7070 for M8 mounting NOT compatible with bases that have stops! Offsets stick fore/aft by 1.15" Made of 5/16" thick mild steel, zinc-plated Two 3/8" thru-holes for 3/8" bolts to mount bracket to stub Reuse existing bolts to mount bracket If mounting to an OE or off-brand base - 8mm adapter bolts may be required! Two 3/8"-24 threaded holes to mount stick to bracket Bolts included (pan head allen rather than hex shown) Both sets of holes are spaced apart 7/8" on center (standard Hurst spacing) Smooth on both sides (no stick serrations) Mate smooth side of Hurst stick to bracket face Mate bracket to smooth side of stub where possible - usually requires flipping stub 180 deg in housing to get smooth faces of stick and stub on same side Apply RTV silicone sealant to mating faces before final assembly, to enhance connections, and torque all bolts to 30 ft-lbs NOTE: dust boot for base must remain in use - this will be hard to do in some cases as this bracket requires the dust boot to be below the stick mount area. We advise to adapt a low-profile OE boot where possible. See our dust boot page Show more