— What do you get? — This frame kit contains everything you need to build your own craft, based off virtually any components. I do however recommend a 4-1 AIO (FC/ESC/RX/VTX) to keep the part count to a minimum, but there should be enough room to stack a separate VTX or RX on top of the AIO It has a 25.5×25.5mm mounting pattern for the AIO, and motor fixations for both 3xM1.4×6.6mm and 3xM1.6×5.5 The camera mount is 3D printed and universal – I will upload the STL and Step files so you may print your own spares or season them to taste 🙂 Features: 75mm diagonal, squished X geometry, for 40mm props 1.5mm Carbon Fiber / Individual Nylon ducts hybrid construction. Cut from Japanese T300 CF sheet Low-profile camera mount, no props in view, no tilt offset Low Center of Gravity, by bringing the AIO closer to the frame/motors Allows mounting with USB pointing up for easy accelerometer calibration No need for a canopy as all electronics are tucked safely between the ducts Maximum rigidity where it matters most; connecting the motors to the FC Easy maintenance, break one duct, replace only the single duct Lightweight, about 21g with HM DiamondF4 Package Includes: 1x Fractal 75, 1.5mm thick Base Plate 2x Printed TPU fixations – 1x 300mah and 1x 450mah 1S (camera, front and rear battery mounts) 13x M1.4x5mm steel machine screw for motors 4x M1.7x5mm self-threading screw for short board grommets 4x M1.7x7mm self-threading screw for long board grommets
