Turtle Crawler FRAKS Flexarm heat insert press kits (1515 Extrusion are sold separately here :https://store.dremc.com.au/products/ldo-1515-extrusion) The Fraks Flexarm is a tool-balancing arm designed to keep the attached tool parallel throughout its movement. It was created to hold soldering irons to install heat set inserts into 3D printed parts. It has a large working area for its size, and has quick release tool holders that are held in place with magnets. Thanks to Zack Freedman for making Gridfinity an open source project, I have included Gridfinity storage into the base. You can read more about Gridfinity at https://gridfinity.xyz/ Whats in the kit Black Carbon Nickel Plated fasteners where possible. (See second photo) Note: This kit use FHCS (For the printed parts) 10mm OD x 1mm Wire Gauge x 60mm Long Extension Springs 4 10mm x 100mm long Pin 1 10mm ID x 14mm OD x 30mm Length Brass Bushing 1 10mmx24mm Washer 1 M3x8 FHCS 20 M3x8 SHCS 15 M3x12 BHCS 6 M3x20 BHCS 6 M5x30 FHCS 10 M3 Heatset Inserts (5mm OD x 4mm Length) 15 M3 Hex Nuts 25 M5 Washers/Shims (10x1) 20 6x3 Magnets 6 6x2 Magnets (For Gridfinity Base) 12 1-1/4 #8 Pocket screws (For screwing base to table) 8 Table Saw Fence Clamp (For clamping to table) 1 Comes with everything but printed parts and extrusion or a soldering iron, if you wish to source them yourself or re-use ones you may already have. Links GitHub - TurtleCrawler/Fraks_Flexarm: A balanced tool arm system A portion of these sales will directly contribute to Turtle Crawler and his future projects, helping bring more innovations to the community
