More Positions, Same Hardware The Hellcat Restraint Bar Set is a purpose-built stainless steel frame accessory for the Strafbock Hellcat with the Gynecology Chair Module installed. The set slots directly into the existing pad receiver tubes on the Hellcat frame — pull out the upholstered pads, insert the two vertical uprights, and the frame is ready. No tools, no drilling, no modifications to the base unit. What you get is a rigid 70 cm crossbar spanning the width of the frame, adjustable in position along both uprights via a pair of cross connectors. Two sliding steel D-rings travel freely along the crossbar and lock where you place them, giving you adjustable anchor points for rope, chain, or cuffs. The result is a versatile overhead tie-off structure that integrates cleanly with the Hellcat's existing geometry — expanding what the combination of the Hellcat and Gynecology Module can do without adding bulk or compromising the base configuration. Stainless Steel Construction, Tool-Free Installation All structural components are stainless steel — the two 90 cm uprights are 35×35×2 mm square tube stock, and the 70 cm crossbar is 30×30×2 mm square tube. The cross connectors that join the uprights to the crossbar are fully adjustable, letting you set the crossbar at whatever height works for your intended positioning. The sliding D-rings hold securely under lateral load and reposition in seconds. The entire set installs and removes without tools, keeping it fully compatible with the Hellcat's modular design intent. Technical Details Upright tube stock: 35×35×2 mm stainless steel square tube Crossbar tube stock: 30×30×2 mm stainless steel square tube Upright length: 90 cm (35.4 in) each Crossbar length: 70 cm (27.6 in) Cross connectors: 2×, fully adjustable for crossbar height positioning Sliding D-rings: 2×, repositionable along crossbar Installation: Tool-free — inserts into existing Hellcat pad receiver tubes Compatible with: Strafbock Hellcat with Gynecology Chair Module Manufactured in Germany What's Included 2× 90 cm stainless steel uprights (35×35×2 mm) 1× 70 cm stainless steel crossbar (30×30×2 mm) 2× cross connectors 2× sliding steel D-rings Note: The Strafbock Hellcat and Gynecology Chair Module are required and sold separately. Adult Use & Legal Disclaimer This product is intended for adult use only. By purchasing and using this product, you confirm that all participants are legal adults and that all use is voluntary, informed, and consensual. The buyer is solely responsible for ensuring that possession and use of this product comply with all applicable federal, state, and local laws. This product is not a medical device or safety equipment. Improper use may result in injury. StyleFetish Industries assumes no liability for misuse.
