The Fuse Blast Polishing System is a drop-in upgrade to the Fuse Blast that allows users to add a smooth, semi-gloss, scuff-resistant, and dye-ready surface finish to their SLS printed parts. This single-step add-on to the Fuse Blast both cleans and polishes your parts straight from the Fuse Sift without the need for another Blast. The Polishing System is compatible with any Fuse Blast and includes: 1 - Fuse Blast Polishing Module2 - Fuse Blast Polishing Media Jugs1 - Fuse Blast Polishing Agent Bottle How It Works While standard glass-blasting leaves a rough, matte surface, the Polishing System cleans and smooths parts in one step through impact polishing. The Polishing Module doses and aerosolizes a small amount of Polishing Agent solution in the blast stream to condition the Polishing Media. This media compacts the part surface, achieving a smooth, semi-gloss finish without removing material, similar to shot peening. A minimum blasting pressure of 60 PSI is recommended for best results. Fuse Blast’s Adaptive Airflow feature enables lower-capacity compressors to handle this increased airflow requirement by pausing the cycle while the compressor recharges. This delivers an uninterrupted, hands-off experience for cleaning and polishing your consumer-ready, SLS parts. Blast Polishing Time: 20-60 minutes Polishing Media Lifetime: > 100 blasting cycles (no breakdown observed) Blasting Pressure: 60 PSI minimum recommended Polishing Agent Lifetime: 7 mL of Polishing Agent is diluted in 750 mL of water. One 120 mL bottle lasts ~130 cycles @ 45 minutes Recommended Flowrate: 2 mL / minute Water Tank Volume: 750 mL
