Get the integrated-boat experience with digital switching that allows the operation of onboard electrical functions right from a compatible GPSMAP or ECHOMAP chartplotter. Quality Switching, Simple Installation Get the integrated-boat experience with digital switching that allows the operation of onboard electrical functions right from the GPSMAP or ECHOMAP chartplotter. Reduce reliance on traditional switches and fuses. Add digital control and software current monitoring. Operate lights, pumps, horn and more. Just tap a compatible chartplotter. Fill up or empty out? See levels in four tanks - such as fuel, freshwater, greywater, blackwater and livewell. See system status. Monitor battery voltage, bilge pump operation and more. Set it up any way. Position and name switches with the easy-to-use interface. Retrofit into any boat. It requires no special tools or configuration. Get Integrated Electrical Control All-In-One: Replace existing two-element systems - fuse box and switches - for easier control and operation of onboard functions. Digital Control: Get control and protection of up to 20 circuits via a Garmin chartplotter rather than a physical button or switch. On/Off Switches: The toggle outputs operate bilge pump and nondimmable lights, such as nav lights and courtesy lights. Dimmable Outputs: Press-and-hold dimmers to set a preferred brightness on board. Momentary Outputs: Control horns and more. Simply press and release for desired length of horn beep. Livewell Timer: A built-in timer turns the pump to cycle the water to keep fish alive - and keep pumps functioning longer. Manage Inputs Monitor Tanks: Experience built-in tank sender detection and calibration for as many as four tanks, such as fuel, freshwater, greywater, blackwater and livewell. Additional Inputs: See analogue voltages on house and start battery, monitor bilge pump operation, and connect optional physical switches. Upgrade Any Boat: Retrofit into existing boats without special tools or configuration by using the included 18″ flying leads and colour-coded channel wires. Key Features Dimensions: 9.1″ x 4.2″ x 1.5″ (230 x 106 x 38 mm) Weight: 14.1 oz (400 g) Enclosure water rating: IP65 Communication: CAN-bus NMEA 2000 network, LEN-0 Output High side: 13 ch 10A, 7 ch 5A Ground contact switch input: 15 Bilge pump monitor: 2 Analog Input Volt: 3 @ 0-16 V +/-1% Analog Input Resistance: 2 @ 0-1500 ohm +/- 5% Power Supply Maximum current: 50A Power off current consumption: 60mA Supply voltage: 9-16VDC Connector NMEA 2000: Micro 5-pin M12 male Connector Channels: Molex MX150 L 16 circuits Power terminals: M6 bolts
