Sheartak Spiral Cutterhead for GENERAL 6'' Jointer 80-150LM1 with 30 carbide inserts Woodworkers are now retrofitting spiral cutter heads to their old planers, and jointers for the following advantages. * Smoother Finish with no tear-out. Each knife sits at a slight angle and it produces a shear cut. Spiral cutter head planes board in a staggered cut which is much better than a single straight cut. The combined shear and staggered cut eliminates tear-out and leaves a glossy surface finish on even highly figured hardwood. * Noise is hugely reduced as the spiral cutter head allows a few knives to cut in a staggered way. * More than 10 times the life use of high-speed steel. The 15x15x2.5mm inserts are made of sintered tungsten carbide which is much harder than high-speed steel. Each insert has four edges. * Easy to change. The knives are precision ground to a tolerance of +/-0.0004" or +/-0.01mm and are interchangeable. Loosen the screw, rotate 90° for a new edge, and tighten the insert in minutes. * Dust extraction is easier. The spiral cutter head produces thinner and shorter chips. * Low cost to use. Spiral cutter heads produce a smooth finish, reduce or eliminate sanding work, don't require sharpening, the product will pay for itself in a very short time. Standard Kit Includes: * High tensile alloy steel cutter block * 30 Carbide Inserts Installed * Two Japan NSK sealed bearing preinstalled. * 5 Additional Carbide Inserts * 5 screws * 1 Torx head T type key
