GEPRC TAKER F722 BL32 E55A SE STACK. *FITS IN GEPRC DoMain BNF Drones.*GP105892 Summary The GEPRC TAKER F722 E55A SE stack is a high-performance stack system aimed at racing. It adopts the mainstream F722 controller, the stable and reliable MPU6000 gyroscope, and an integrated 32Mb flash. The overall performance is reliable and stable. The wiring of the flight controller supports welding and SH1.0 terminal plug-and-play, which is convenient for installation and application. The TAKER E55_96K BL32 4IN1 ESC 55A uses metal-encapsulated MOS tubes with a measured continuous overcurrent of 50A and an instantaneous current of 55A, fully meeting the requirements of professional drone racing. All stacks mounting hole size is 25.5 x 25.5MM, which is compatible with most frames in the market for installing AIO flight controllers. The stack combination can help dissipate heat from the main controller and MOS tubes. Features The new TAKER series, a high-performance stack system, adopts a 2306.5 1350KV motor and 7.5-inch drone for testing and can operate stably. Adpots mainstream F722 main controller with MPU6000 gyroscope. 32Mb black box storage. Support receiver, analog camera, and support plug-in of the DJI Air Unit directly. The design of 10V 2A+5V 2.5A dual-channel independent BEC. The customized 25.5mm x 25.5mm mounting holes are compatible with most of the AIO frames in the market. TAKER E55_96K BL32 4IN1 ESC 55A metal package MOS tube ESC possesses a better heat dissipation effect and performance. Specifications TAKER F722 SE FC MCU: STM32F722RET6 IMU: MPU6000 Black Box: 32Mb Flash USB: Type-C OSD: BetaFlight OSD w/ AT7456E chip BEC output: [email protected]，10V@2A dual-output BEC Firmware Target: TAKERF722SE Dimension: 31.7×31.5mm Moutning hole sizes：25.5×25.5mm，mounting hole size is φ4mm, use vibration reduction silicone to transform the fixing screws into 3mm or 2mm. Input voltage: 7.4V-25.2V（LiPo 2-6S) UART: 6 UARTS(for Uart6 ESC only) Power Filter: Integrated LC filter Weight: 6.0g TAKER E55_96K BL32 4IN1 ESC 55A Input Voltage：7.4V-25.2V（LiPo 2-6S) Galvanometer：Support PWM refresh frenquency: 24K-96K Continuous Current：55A Burst Current：60A (5s) Telemetry: Support Support Protocol：Oneshot125/Oneshot42/Mulishot modes Dshot 150/300/600 Firmware Target: ST_G0_05 Weight:：9.6g Includes 1 x Flight control 1 x ESC 1 x 35V 470uf capacitor 1 x XT60 power cord 1 x 8pin flight controller ESC cable 4 x M3*22 screws 6 x M3 anti-slip nuts 12 x 4 convert to 3mm vibration-reduction silicone 12 x 4 convert to 2mm vibration-reduction silicone 1 x 65mm camera lens cable 1 x 25mm camera lens cable 1 x Receiver cable 1 x DJI Air Unit Cable connector
