Our trigger shoe has been designed for a better shooting feel. It is designed for the best possible trigger pull when using a serial trigger bar. The flat design provides a consistent feel and its width prevents any "digging" into your finger. Made of aluminum alloy with a hard anodized finish. The use of a stock trigger bar means that all three factory safeties remain intact. This requires no modifications to the springs, trigger bar, or connector. Installation can be done in minutes. Simply remove the old trigger bar and pry out the original trigger shoe with a punch. Compatible with all Glocks generation 3,4,5 - also compatible with Slimline models - G42/43/43/43X/48 and also compatible with Gen 5 Glock Performance Trigger. !!! NEW !!! Trigger shoe compatible with all Glocks generation 6. No +SEAR needed on GEN 6 pistols. Explanation of the +Sear variants: since Glock came out with a new revision of the GPT, which is described as being for Gen 4/5, where they changed the dimensions of the sear dramatically (due to Gen 4 pistols), there was a problem when cocking with a non-stock reed installed. This problem was due to the height of the sear. So, in order to make things right for Glock, we decided to make our own not only reeds, but also sears - so we didn't invent anything there, and just made them exactly as they were in GPT until now. Any other solution would have affected the trigger behavior in a way that would have eliminated our pretravel elimination due to the changed geometry, and then that would have missed quite a point, wouldn't it. So in short - If you have the Glock Performance Trigger for Gen4/5, you need the +Sear variant. If you have an original trigger or an older version of the GPT, you don't need the extra sear. Anyone can do the swap at home, all you need is a small pair of pliers and a screwdriver. You will find the manual here.
