GUNPRIMER Panel Line Guide 1 (Pattern No.1)Guide Tape Number: 2 sheets / 96 pieces Size Variations:Width 0.1mmWidth 0.3mm Horizontal width of the groove: 28mm (typical) A sheet type set of streaking guide tapes.The Panel Line Guide 1 series is mainly designed for new creators. This pattern guide is a tool to accurately and easily carve a mechanical model straight line. Usually, when these panel lines are reproduced using guide tapes, they are carved by sticking finely cut guide tapes in several places, but it is also very difficult to engrave the same panel lines symmetrically on the sides of such as legs. This guide tape simplifies and streamlines these tedious tasks and helps ensure that you avoid overruns (failed to carve excess parts) just like other panel line guides. Also, It's a bit more soft than the various cutting guide tapes, and it's even a little curved, and it doesn't leave any glue when peeling off. Each product has 2 sheets. on each sheet (1) Diagonal length: 12 pieces each of 2,3,4,5 mm, 48 pieces total. (2) Diagonal length opposite to 1sheet is 2,3,4,5mm, 48 pieces total. A total of 96 guide tapes are posted. [Notice] ※ One guide seal can be used several times if it is not heavily stained, dust, oil, etc. Also, please remove the streaked dust with a clean brush immediately after it gets dirty. *Please take off the oil and dust on the surface to be pasted before pasting.Also, be careful not to touch the adhesive surface as much as possible when you touch it with your fingertips.
![Gunprimer: Panel Line Guide 1 [Pattern 01]](https://cdn.shopify.com/s/files/1/0689/4354/4640/files/892f8a_0f90a95bd9ba4211a9d1bbfd3d069c15_mv2.png?v=1736562825&width=480)
