Quick Specs Sliding rails allow a system to be fully extended out of the rack for service. Most sliding rails support Cable Management Arms (CMAs) which enable the system to be extended out of the rack without disconnecting data/power cables at the rear of the system. Unless otherwise indicated, all sliding rails are drop-in sliding rail design Cable management arm (CMA) is a cable management accessory which connects to the rails behind the system. It allows a fully cabled system to be extended out of the rack into a service position. Strain relief bar (SRB) is a cable management solution, which in most cases, attaches to the back of the rails via the strain relief bar brackets. Cables from the back of the chassis are placed across the top of the SRB and secured by straps. Square-hole describes a 4-post rack mounting flange type where rails utilize Square holes sized according to EIA-310-D standard for mounting. Round-hole describes a 4-post rack mounting flange type where rails utilize Unthreaded-Round holes sized according to EIA-310- D standard for mounting. Threaded-hole describes a 4-post rack mounting flange type where rails utilize Threaded-round holes for mounting. Threaded round holes may require additional hardware for mounting and hardware may vary by thread type. See footnotes in table 2 for specific information on threaded-round hole mounting. Part Number: H99Y8 Rail identifier Mounting interface Rail type Rack types supported Rail adjustability range (mm) Rail depth (mm) 4-Post 2-Post Square Round Threaded without CMA/SRB with CMA(SRB) Square Round Thread Flush Center Min Max Min Max Min Max A15 ReadyRails II Sliding X X X a,c,d - - 631 868 617 862 631 884 736 b 862(770/792) a Minor conversion requiredb With CMA brackets removedc Mounting screws not included in the kitd Mounting screw head diameter must be 10 mm or less
Related
Related