This is a physical print out that will be mailed to you. All sizes are based on the longest side. DTF Transfers can go on any T-shirt. It has a thinner feel than vinyl. **Must use a Heat Press *** LOGO and Watermark will NOT be on your transfer*** Pressing Instructions DTF TRANSFERS DTF - Heat press temperature should be set to Polyester and Polyester Blends 285-Cotton 300 F. Use Medium to heavy Pressure to press the moisture out of your shirt and then press the transfer on the shirt for 12 seconds and peel transfer carrier. If there are small elements in the design, let it cool completely before removing the transfer film. Use a cover sheet (Teflon or white butcher paper/copier paper) after you’ve peeled the transfer, press again for 5-10 seconds. If for any reason that the print begins to lift off the shirt, usually due to an inexpensive heat press Don’t freak out, STOP PEELING AND PRESS IT AGAIN. Most likely your heat press has uneven pressure and heat. Machine wash cold Tumble dry low Sublimation Transfers This transfer is to be used with your heat press for applying designs to your shirts, can coolers, or any sublimation blanks. A HEAT PRESS is a MUST to applying any Ready to Press Designs. (An iron will NOT work) • High Poly Tee (at least 65% Poly. 100% is best) or any Sublimation Blank to press the design on. • Your Heat Press should be set to 385 - 400 Degrees F • Medium Pressure • For 60 Seconds. • Pre-press your garment for 3-5 seconds to remove any moisture • Place a sheet of paper inside the garment, (copy paper is fine). Directly under where you are putting the design. • Place your sublimation print face down on the garment • Cover with white butcher paper. • Press • Remove Butcher paper and Transfer Print immediately after pressing **** Times, temperature, and pressure may vary slightly with different heat presses **** • Sizes are listed as general popular sizes most commonly ordered for tees. • All transfers are non-refundable. • No returns are accepted. • When you purchase this Ready to Press Transfer, you are agreeing that you are responsible of any outcome of your end product, and that you will be using the correct equipment needed. You are also agreeing that you have fully read the instructions, and you understand the application errors are the responsibility of the buyer (you). **** CCMbyCrystal is NOT responsible for lost or stolen mail.****
