The Wireless Air Sensor supplied by Kings Plumbing Supplies can be used with the Touch V2, Edge and Neo System and can be used as a single temperature sensor or as part of a group when an averaged temperature reading is required. The Wireless Air Sensor pairs directly with the Touch v2 and Edge whereas with the Neo System the Wireless Air Sensor is paired to the neoHub G2 and then linked to the appropriate zone. Using the Wireless Air Sensor with the Neo System With this new addition, your Neo system is now even smarter. The wireless air sensor allows you to measure the temperature from a single wireless air sensor or multiple sensors if you are looking to average the temperature over a larger area. Our Wireless Air Sensor pairs to the neoHub G2 using the Android or iOS apps. Once linked, you can decide how the system will operate; Monitoring – This allows you to simply measure the temperature in another area of your home. Pair to Zone – This allows you to pair the sensor to a neoStat you already have setup in your system. If you select Pair to Zone, you now have 2 options. Averaging – If you select this option, the thermostat will average the temperature with the internal sensor in the thermostat. Remote Only – If you select this option, the internal sensor will be turned off and the remote sensor will become the air sensor for the zone selected. If you then pair additional remote sensors, the system will then give an averaged reading. Specification Range: 40 meters open space. Please note the wireless sensor pairs directly to the neoHub G2 and does not benefit from the mesh network. Therefore you may require additional neoPlug or Boosts to extend the signal around your home. RF Frequency: 868MHz IP Protection: IP20 Download the Wireless Air Sensor Datasheet Important Neo Compatibility Notes RF Sensor support is only available on the neoHub G2. To determine if you have a neoHub G2, look at the rear of your neoHub for a label marked “2nd generation” If in doubt contact the Heatmiser support team on 01254 669090. The RF sensors are not visible in HomeKit The RF sensors communicate directly to the neoHub G2. Depending on signal strength in your home, you may require additional boosters such as the neoPlug or Boost. For compatible thermostats, consult the wireless air sensor datasheet. Be sure to check out our kits, and if you are looking for a personal touch, please send your drawings and plans to [email protected], we offer free quick designs and quotations, should you wish to proceed with your order we will supply a free detailed CAD Design.
