We've created a utility packed lighting solution. This flashlight is mounted on an incredibly sturdy 4.5" industrial vacuum mount. Mounted and removed in mere seconds, this flashlight can be installed on any non-porous surface. Equipped with a 7" rigid flex arm that allows for quick adjustments for direct light in any direction. Size & Specifications: Fully assembled flashlight measures approx. 4.5" wide, 15" tall. With a single button click, you will turn on the main flashlight. You are able to choose between three settings - high white light, low white light, and white strobe light. With two clicks of the button, you will turn on the side flashlight. You are able to choose between four settings - high white light, low white light, red light, and red strobe light. When assembling your Flashlight Mount, make sure you are threading the end of the flex arm with the rubber gasket into the threads on the bottom of the flashlight. This guarantees that the flashlight maintains its watertight seal. FAQs: Q: How strong are the vacuum mounts? A: “Strong like bull.” 4.5” vacuum mounts have a rated pull strength of 120lbs, pulling straight out from center. Pull strength on a shear load, i.e. pulling from the side, will be less. 6” vacuum mounts are 210lbs rated. Obviously, putting multiple vacuum mounts on a single product multiplies the maximum holding power. Q: How long do the vacuum mounts last before they lose power? A: There’s no set time limit on our vacuum mounts. It depends in part on the surface you attach to, the condition of the vacuum mount, the load you put on it, and other factors. As for surfaces to attach to, vacuum mounts in general were designed to carry big sheets of glass and other solid surface materials, so smoother, flatter surfaces are ideal. Clean surfaces and clean SeaSuckers go a long way to maximizing the hold time. In any event, if the vacuum mount begins to lose some vacuum, it will warn you so you can get it back to full power before it comes off. The vacuum pump’s plunger will extend from the pump cylinder when it starts to lose power, revealing an orange indicator band. Once you see orange, that’s your cue to repump your SeaSucker. For car racks, the simplest thing to do is to check the rack before you get in your vehicle, and check it each time you stop for gas, food, or the bathroom. Q: Do I need to clean the surface I’m going to attach my SeaSucker to? A: Clean off any surface dirt from the mounting surface before attaching your SeaSucker. While you’re at it, make sure the sealing edge of the vacuum pad is clean too. You don’t have to clean the mounting surface with alcohol wipes, as one overly-enthusiastic customer told us they do, but a quick wipe with a wet paper towel or napkin wouldn’t hurt.
