Wireless Tracker V2 powered by ESP32-S3FN8, integrates SX1262 and UC6580 to support WiFi, Bluetooth, LoRa, and GNSS. With a built-in PA, it delivers a transmit power of 28±1 dBm. This is US 900 MHz version.The Wireless Tracker V2 is built around the ESP32-S3FN8 and integrates the SX1262 LoRa chip along with the UC6580 GNSS chip.This new generation Wireless Tracker V2 incorporates a power amplifier, achieving a maximum transmission power of up to 28±1dBm. The LNA can be bypassed without affecting reception performance.The Wireless Tracker V2 features LDS antennas for both GNSS and 2.4G, significantly reducing the device’s size.It is widely used in fields such as personnel positioning, asset tracking, LoRaWAN, Meshtastic, and MeshCore. Main Features Supports Wi-Fi/Bluetooth, LoRa, and GNSS communication. Integrates a power amplifier with a maximum output power of 28±1dBm, and the LNA can be bypassed. Supports multi-system joint positioning including GPS, GLONASS, BDS (BeiDou), Galileo, NAVIC, and QZSS. Integrated lithium battery management system (charge/discharge management, overcharge protection, battery power detection, automatic switching between USB and battery power). USB-C interface with comprehensive voltage regulation, ESD protection, short circuit protection, and RF shielding. Supports the Arduino development framework, providing LoRa/LoRaWAN examples. Compatible with Meshtastic and MeshCore. Specifications Parameters Description MCU ESP32-S3FN8 (Xtensa®32-bit lx7 dual core processor) LoRa Chip SX1262 GNSS Chip UC6580 Frequency 902~928MHz Max. TX Power 28±1dBm Max. Receiving Sensitivity -134dBm Wi-Fi 802.11 b/g/n, up to 150Mbps Bluetooth LE Bluetooth 5,Bluetooth mesh Hardware Resource 7*ADC1 + 2*ADC2; 7*Touch;3*UART;2*I2C; 2*SPI; etc. Interface Type-C USB;2*1.25 lithium battery interface;2*1.25 solar panel interface;LoRa ANT(IPEX1.0);GNSS ANT(IPEX1.0);2*18*2.54 Header Pin Battery 3.7V(3V-4.2V) lithium battery power supply and charging Operating Temperature -20 ~ 70 ℃ Dimensions 52.00*25.40*10.26 mm Layout Pin Map Dimension Dev board return policy Development boards are specialty items that generally cannot be resold on return, especially if the firmware has been flashed. Defective boards can be replaced or returned for refund within 30 days of purchase. Non-defective boards can be returned in the same time frame if in like-new condition with a 20 percent restocking fee applied. If the board has had altered firmware or became bricked due to a non-standard firmware flash, the board may not be eligible for return. Sales tax is required in many states and will be added at checkout if applicable to your delivery state. Tax exempt forms can be sent to our support department.
