HH-66 Thinner is designed primarily for use with HH-66 Vinyl Cement. This solvent-based thinner reactivates dried HH-66 Vinyl Cement or removes unwanted HH-66 from surfaces. You also can use HH-66 Thinner to clean brushes, rollers, spray guns, and other types of applicators. Since HH-66 Thinner is flammable, it should be used in a well-ventilated area. Handle empty containers with care, as any residual solvent is flammable. - Formulated specifically for use with HH-66 Vinyl Cement - Designed for thinning, spraying, reactivating, prepping, and cleaning your project and tools HH-66 Thinner Application Instructions Q: If your coat of HH-66 Vinyl Cement is no longer tacky A: Use a brush or roller to apply a light layer of the appropriate HH-66 Thinner directly to the application. Bond the pieces together as per the adhesive directions. Q: If the HH-66 Vinyl Cement has thickened in the container A: Add up to 20% HH-66 Thinner until the original consistency is reached. Mix until evenly dispersed. Q: To clean HH-66 Vinyl Cement from brushes, rollers, spray guns, and other types of applicators A: Follow the manufacturers' recommended cleaning procedure. It is recommended to clean the applicator immediately after use. HH-66 Thinner is flammable and should be used in a well-ventilated area. Handle empty containers with care as residual solvent is flammable. Q: If the HH-66 Vinyl Cement is too thick for your application A: Add HH-66 Thinner as needed (up to 20% thinner). Mix until evenly dispersed. Over-dilution can cause loss of bond strength. A second application may be required to achieve the appropriate coverage for a good bond. Q: To spray HH-66 Vinyl Cement, HH-66 Thinner can be used to dilute the product A: Usefulness depends on the sprayer and application. It is not recommended to use more than 20% thinner for spraying. With diluted adhesive, a second application may be required to achieve the appropriate coverage for a good bond.
