PM06D provides a regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6-pin cable. It has built-in power distribution, allowing you to power your ESC and FC with the same board.The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with an XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact. Package Includes: 1x PM06D Power Module 1x 6-pin 2.00mm pitch cable NOTICE: PM06D is supported by PX4. For Ardupilot, it is supported in version 4.4 and later. This PM uses I2C digital signal data output and is not compatible with flight controller that uses analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers. Specifications: Input voltage: 2S- 14S PCB Cont. Current Rating: 70A PCB Burst Current Rating: 120A (
