Full Specifications General Dexterity: Right-Handed Number of Strings: 7 Size: Full Size Build Difficulty: Intermediate (5/10) Basswood is a closed-grain wood, so no grain filling is needed before finishing Bolt-on neck joint bolts straight on, so there is no gluing or clamping to get right Tune-o-matic bridge sets intonation quickly once the posts are seated Body Material: Basswood (2-4 pcs) Type: Solid Cutaway: Single Binding: Single Black Top Veneer: None Neck Material: Maple w/ a Skunk Stripe Joint: Bolt-on Profile: C-shaped Truss Rod: Two-Way, Adjustable Scale Length: 27 inches (685.8mm) Binding: Ivory Fretboard Material: Maple Radius: 14" / 356mm Number of Frets: 24 Fret Wire: Stainless Steel Fret Size: Medium Jumbo Inlay Shape: Dot Inlay Material: Black Plastic (ABS) Headstock Shape: Standard (as in product images) Binding: Ivory Nut: Bone (Real) Electronics Neck Pickup: Humbucker Bridge Pickup: Humbucker Controls: 2 Volume, 2 Tone, 3-Way Toggle Wiring: DIY (soldering required) Wiring Diagram: HH, 2 Volume, 2 Tone, 3-Way Toggle Switch Output Jack: Side jack Hardware Bridge: Tune-O-Matic w/ stopbar Tuners: Closed Pickguard: None Knobs: Chrome Cavity Covers: Black Strings: Steel Finish: Black What's in the Box Unfinished pointed single-cutaway body with body binding, routed for two humbuckers and a rear control cavity Maple neck with maple fingerboard, side dot markers and a drilled headstock 7x black sealed tuners 2x black open humbucker pickups with adjustable pole screws in black mounting frames 1x pre-wired control harness with potentiometers and hookup wire 1x three-way toggle switch with black tip 4x chrome dome knobs 1x black bridge with seven adjustable saddles 1x black stop tailpiece bar 2x black bridge posts and 2 black bushings 1x black neck plate 4x long black neck mounting screws 1x black plastic control cavity cover 1x black jack plate with output jack 1x black truss rod cover 1x set of chrome washers, nuts and lock rings 2x bags of small black hardware parts 2x black strap buttons 1x set of strings 1x Allen wrench 1x guitar cable with one angled plug What You'll Need You will need to solder the electronics. Depending on the finish you choose, the tools below cover a standard build. For assembly: Phillips screwdriver, Allen wrench set For wiring: Soldering iron, solder, wire cutters For finishing: Sandpaper (220-600 grit), primer, paint or stain, clear coat For setup: String winder, guitar tuner, Allen wrench for truss rod and saddle height adjustment No woodworking or routing required - all cavities, holes, and channels are pre-cut.
