Material Specification: PET Composition Thickness:145 Microns / 5.7 Mils (Please make sure plotter is capable of cutting such thickness) Heat pressure sensitive backing Special Design Finish Application Instruction (Home Iron) Set iron dial between Cotton and Linen Cover design with Kraft paper or non-stick cover sheet Place on flat, hard surface (ironing board not recommended) Press iron with medium/firm pressure (do not slide iron) Press each section of design for 10-15 seconds If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds let it cool for about 30-45 seconds and then gently peel back the clear plastic until it is completely removed. Application Instructions (Heat Press) Cut in reverse Weed excess material Preheat all fabric prior to pressing for best results Apply design at 305°F/150°C for 10-15 seconds let it cool for about 30-45 seconds and then gently peel back the clear plastic until it is completely removed. Applies to: 100% Cotton Poly / Cotton Blends 100% Polyester Leather Laundering: Wait 24 hours before 1st wash Machine wash warm or cold / mild detergent Dry on normal dryer setting Do not bleach or dry clean Note: Material will be rolled for shipment. Due to the nature of the material, wrinkles might appear after unroll. In this case, peel off the transfer tape (clear film) and re-apply transfer tape onto the film with heavy flat item on top such as yellow page for 15 minutes, the film will be back to the flat shape.
Related
Related
Related
Related