The Hunter FCT208 Flow-Clik sensor receptacle tee is a Schedule 80, 2" (50 mm) slip x slip fitting designed to house Hunter Flow-Clik (Flow-Sync) sensors. Built for irrigation mains and branch lines, the FCT208 provides a protected, inline mounting point that maintains full-bore flow while allowing quick sensor access. The fitting is molded in gray PVC-U Schedule 80 and uses solvent-weld (glue) slip connections for permanent installation. Specifically designed for Hunter Flow-Clik / Flow-Sync sensors — houses the sensor securely inside the tee. 2" (50 mm) Schedule 80 PVC-U construction in gray — durable for buried and exposed irrigation runs. 2" slip x slip inlet/outlet for standard solvent-weld installation; inlet/outlet size: 2". Sold as the tee fitting only — Flow-Clik sensor and electrical accessories are ordered separately. Reduces potential water loss by providing a dedicated mounting point for flow detection and automatic shutoff when paired with a Flow-Clik sensor. Documents and support materials are available from Hunter, including installation instructions, owner’s manual, and product cutsheets to guide mounting orientation and wiring of the matched Flow-Clik sensor. Install the FCT208 in a straight run with adequate pipe access and follow solvent-weld best practices and local plumbing codes. For system calibration and controller integration, use Hunter documentation or consult with your irrigation contractor to select the correct Flow-Clik model and programming settings. The FCT208 is a simple, long-lasting solution to add flow detection capability to 2" irrigation lines when paired with Hunter flow sensors.