The HX711 Load Cell Amplifier from PMD Way is a small breakout board for the HX711 IC that allows you to easily read load cells to measure weight. By connecting the amplifier to your microcontroller you will be able to read the changes in the resistance of the load cell, and with some calibration you’ll be able to get very accurate weight measurements. The HX711 uses a two-wire interface (Clock and Data) for communication. Any microcontroller’s GPIO pins should work, and numerous libraries have been written, making it easy to read data from the HX711. Check the hookup guide below for more information. Load cells use a four-wire Wheatstone bridge configuration to connect to the HX711. These are commonly colored RED, BLK, WHT, GRN and YLW. Each color corresponds to the conventional color coding of load cells: Red (Excitation+ or VCC) Black (Excitation- or GND) White (Amplifier+, Signal+ or Output+) Green (A-, S- or O-) Yellow (Shield) The YLW pin acts as an optional input that is not hooked up to the strain gauge but is utilized to ground and shield against outside EMI (electromagnetic interference). Please keep in mind that some load cells might have slight variations in color coding. Free delivery, worldwide. Schematic: Features: Operation Voltage: 2.7V–5V Operation Current: < 1.5mA Selectable 10SPS or 80SPS output data rate Simultaneous 50 and 60Hz supply rejection More information: Schematic Eagle Files Hookup Guide Getting Started with Load Cells Datasheet (HX711) GitHub (Design Files & Example Code) GitHub (Library) Based on an open-source design by SparkFun Don't forget to check out our full range of sensors if this doesn't meet your needs. And as always, all orders receive free delivery. And remember ... if you: can't find what you need not sure what to order want a bulk deal need technical support or just want to have a talk ... Please email us via [email protected]. To keep up to date with new products, news, tutorials and more - we're on x, Facebook, Instagram, threads, reddit, and instructables.
