.product-info-tutorial{margin-bottom:20px;}.product-tutorial-img-container{width:20%;}.product-tutorial-img-container img{margin:0;}version="1.0" standalone="yes"? A lot of debug adapters cost money that you'd much rather spend on tinkering. But not the IBDAP - CMSIS-DAP JTAG/SWD Debug Adapter Kit from armstart - a vendor independent debug interface that works with your PC over USB and targets ARM devices over its JTAG/SWD pins. Fully supported by most commonly used debugging tools, the IBDAP kit is able to perform debugging functions like stepping, breakpoints, watch points, and firmware downloads. While debugging's the IBDAP adapter kit's primary use, it can also be used as a general development board with a ARM Cortex M0 processor. Comes as a fully assembled CMSIS-DAP debugger board, a 2x5-SWD-to-2x10-JTAG adapter and a SWD 2x5 0.05" pitch connector cable. Technical Details Note: As of Monday, November 30th 2015, we are selling this kit with a longer SWD cable, measuring now at approximately 156mm / 6.1in. Schematics User Manual GitHub repo with ARMstart IBDAP CMSIS code A helpful blog post on using with the SAMD21 NXP LPC11U35FHI33/501 ARM Cortex M0 48Mhz processor 64kB Flash 12kB RAM 2kB EEPROM 1 x USART 1 x I2C 2 x SPI 1 x USB2.0 8 x ADC(10-bit) 26 x GPIO Supports mbed programming IBDAP board dimensions: 27mm x 51mm x 11mm / 1.1" x 2" x 0.4" Adapater board dimensions: 24mm x 43mm x 12mm / 0.9" x 1.7" x 0.5" Includes: 1 x Armstart IBDAP board 1 x 10-pin (0.05'') JTAG cable 1 x IBDAPC10J20 20-pin (0.1'') to 10-pin (0.05'') JTAG adapter 1 x 2mm Pitch 40-Pin Break-apart Male Header Learn Programming Microcontrollers using OpenOCD on a Raspberry Pi Native GPIO bit twiddling your way to success Bluefruit nRF52 Feather Learning Guide Get started now with our most powerful Bluefruit board yet! Bootloading Basics Pulling your processor up by the bootstraps.
