Recommended for performing routine maintenance on the Viper XPT-6000 and the ViperONE, Image Armor Cleaning Solution breaks down active polymer solids and will cleanse all inner systems: pumps, solenoid valves, fittings, tubes, and spray nozzles. The cleaning solution also cleans all internal and external surfaces that have pretreatment residue. Image Armor Features Non-Flammable Safe for Viper XPT Interior Components Biodegradable Environmentally Friendly Low VOC, Zero GWP Non-Ozone Depleting, Halide-Free Prevents Ionic Contamination pH in neutral range (6-9 pH) Non-Corrosive Directions for Cleaning the Viper XPT-6000 The Image Armor Cleaning Solution is designed to recirculate through your Viper XPT-6000 though the H2O Fluid IN and OUT ports. It is recommended that you use a separate container to hold recirculation fluid. Empty the Viper of pretreatment by running a Fluid Empty routine Place the water IN and OUT fluid lines into the container of Image Armor Cleaning Solution. Run a Fluid FILL routine. To fully clean and maintain the Viper, run 3-5 cycles of the fluid FILL routine. Empty the Image Armor Cleaning Solution by running a Fluid Empty routine. Place the water IN line back into a clean container of distilled water. Place the water OUT line back into your waste water container. Run two Fluid FILL routines using distilled water to remove the residue of the Image Armor Cleaning Solution from lines, pump and spray heads. Empty the water from the Viper using the Fluid EMPTY routine on the Viper. You are ready to re-introduce pretreatment into the Viper and start pretreating.
