iniBuilds A300 Autopilot ProfileWith the Flight Panels Autopilot Profile for the iniBuilds A300, you can control autopilot, communications, navigation, EFIS, transponder, internal lighting and more, all from the Stream Deck +’s physical buttons, LCD touchscreen and rotary dials. Watch speed, heading, vertical speed, altitude and frequencies update in real time as you turn the dials, adding a new level of realism to your flight simulation experience. For a comprehensive list of features and functionality (which may vary between aircraft), please see below. Flight Control Panel (FCP)Button Controls: Autothrottle (A/THR), Altitude Hold (ALT HLD), Level Change (LVL CHG), Profile Mode (Profile), Heading Select (HDG SEL), NAV Mode (NAV), VOR/LOC Mode (V/L), Land Mode (LAND). Rotary Dials & LCD Screen: Real-time values for speed, heading, altitude & vertical speed. Rotate the rotary dials left or right to increase or decrease values. Speed (SPD): Tap the screen to enable pre set and press the rotary dial to enable selected mode. Altitude (ALT): Tap the screen to change between 100/1000 increments and press the rotary dial for Altitude Pull. Heading (HDG): Tap the screen to change bank mode and press the rotary dial to enable heading selected mode. Vertical Speed (V/S): Press the rotary dial to enter V/S mode. Radios & CommunicationsButton Controls: Autopilot 1 (AP1), Autopilot 2 (AP2), CWS/CMD. Rotary Dials & LCD Screen: Real-time frequency values for COM1/COM2 (Active and Standby). Rotate rotary dials 1 and 2 to change the standby frequency for COM1 and dials 3 & 4 for COM2. Tap the screen or press a standby rotary dial to swap between Standby and Active. XPDNR/TCASButton Controls: Above/Below (ABV/BLW) (Long press for N), TCAS Range, ALT TCAS System (Long press to turn off), TCAS Test, IDENT, XPNDR Mode, & XPNDR SYS. Rotary Dials: Rotate the rotary dials to increase or decrease each of the transponder digits. NavigationButton Controls: ADF1 Transfer (ADF 1 TFR), ADF 1 Tone, ADF/ANT Mode. Rotary Dials & LCD Screen: Rotate rotary dials 1 and 2 to change the active ADF 1 frequency and rotary dials 3 & 4 to change the standby frequency. Press any rotary dial to change between active and standby.
