Precision and Power for Professional Gimbal Systems The iPower GM8112-80T Encoder Combo Set is engineered for high-end 3-axis gimbal systems that demand exceptional accuracy and smooth performance.Equipped with AS5048A encoder technology, this combo delivers precise position feedback and ultra-stable motion control — ideal for SLR cameras, professional drones, and advanced cinematography setups. Why Encoder Technology Matters Encoders are advanced sensors that measure motor position in real time, enabling unmatched precision and control.Compared to standard brushless gimbals, the GM8112-80T with encoder system offers: Up to 5× longer operating time through improved power efficiency Instant torque response and faster reaction to movement Superior stability even at extreme angles Simplified setup – minimal calibration required The system combines active motor-driven stabilization with passive inertial balance, continuously monitoring movement across the Pan, Tilt, and Roll axes.Each encoder-equipped motor reacts instantly to keep your footage smooth, steady, and cinematic. Key Features Easy gimbal tuning with minimal calibration Power-efficient — up to 5× longer runtime than standard gimbals Dual IMU sensors for enhanced stability Instant torque response with no dead angles Equipped with high-precision AS5048A encoder chip Specifications Model: GM8112 Motor Out Diameter: Ф89.5±0.05mm Configuration: 36N/42P Motor Height: 33.4±0.2mm (Included with Encoder housing) Hollow Shaft(OD): Ф25-0.008/-0.012 mm Hollow Shaft(ID): Ф22+0.05/+0.1 mm Wire Length: 610±3mm Cable AWG: #24 Motor Weight: 446±1g Wire plug: 2.5mm dupont connector No-load current: 0.3±0.1 A No-load volts: 22V No-load Rpm: 380~420 RPM Load current: 2A Load volts: 20V Load torque(g): 6000-9000 Motor internal resistance: 4.2Ω±5%（Resistance varies with temperature） High voltage test: DC500V 1mA @2sec Rotor housing runout: ≤0.1mm Steering (axle extension): clockwise High-low temperature test: High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature Maximum power: ≤80W Working current: 3-5S Working temperature: -20~60℃;10~90%RH Compatible Sliprings iPower Gimbal Motor Slipring - OD 7.9mm iPower High Current Gimbal Metal Slipring - OD12.5mm Packing List 3 x GM8112 Gimbal Motor with AS5048A Encoder & Magnet 1 x Alexmos 32BIT BGC Board Encoder version without alum case 1 x Connecting cables set
