Customize your bag, jacket, or any fabric with our new patch! At 3″ in diameter, it has a die cut border and heat-seal (iron-on) backing so you can easily attach it. Here are the iron-on instructions: Note: Heat seal does not work on nylon or other synthetic materials. Heat press : 375 deg. for 18-25 secondsHome iron : Highest setting (cotton) NO STEAM! Keep firm pressure for 30 seconds.1) Wash fabric first. Fabric softener should not be used.2) Set iron to cotton setting. Do not use steam, and remove water from iron.3) Lay your garment out on a hard, heat tolerant surface. A padded ironing board is not hard enough. Try placing a cutting board above padding.4) Place heatseal side of patch onto fabric in desired placement area. Iron design for approximately 20-40 seconds, applying pressure. Do not move iron side to side as this may cause design to shift. Heavier fabrics may require more time, and lighter fabrics may require less time.5) Allow time to cool, then make sure entire surface area is applied to fabric. If all pieces did not adhere, reapply heat for an additional 20-30 seconds. Allow to cool.6) Turn garment inside out and apply iron to back of design area for approximately 30 seconds.7) Wait 48 hours before washing, and turn garment inside out when doing so.
