This set includes x4 bushing halves and x2 steel tubes. All the pieces needed for 2 engine mounts. These bushings were made to replace the engine mount bushings on the minitec J swap engine mounts. The original bushings appear to be insufficient and fail quickly. The DRW design bushings are thicker to fill the whole mount and provide more support. You can see the photo below where the original Red bushings are next to the Black DRW bushings.I am not certain if there are different sizes of engine mounts that may have come from minitech for this application, so please verify that your mounts dimensions match the ones shown in this listing. Please message me if you have any questions about this item fitting your specific vehicle or for any other questions. Disclaimers Color. The formulation of polyurethane that I use to make bushings is chosen because of its high physical strength properties. An unfortunate downside of this type of polyurethane is that it can darken or discolor over time. Especially if it is exposed to UV light. This discoloration has no affect on physical properties but it only aesthetic. I highly recommend not leaving the bushings exposed to sunlight before they are installed. Obviously once installed, sunlight exposure isn't much of an issue but darkening may still occur. Liability. All products sold or manufactured by DRW Bushings are intended for off-road use only. Customer assumes all liability in assuring that parts are installed correctly, maintained, and not modified or altered in any way. DRW Bushings is not responsible or liable for any accidents, injuries, or deaths that may occur from the use of any products offered. Suspension modifications may change the dynamics and stability characteristics of the vehicle. Ensuring prompt wheel alignment after suspension modifications is critical and the sole responsibility of the customer.
