DESCRIPTION This Wireling lets you use a discrete joystick for inputs to your project! This Up, Down, Left, Right joystick board interfaces with an I2C I/O expander to be read by the an Arduino processor or Raspberry Pi! *Please note that this is not a full range joystick. It is a discrete joystick which is essentially 4 buttons mounted sideways at the base of the joystick knob. New to Wirelings? Check out the Wireling Overview! Note* 5-Pin Wireling cables not included and sold separately. TECH SPECS SX1505 Specs 8 Channel GPIO with NINT and NRESET Fully programmable logic functions (PLD) SKRHABE010 Joystick Specs 4 Directional Digital Joystick Center Pushbutton Input I2C Semtech SX1505 I/O Expander TinyDuino Power Requirements Voltage: 3.0V - 5.5V Current: 1.0uA (Normal Mode). Due to the low current, this board can be run using the TinyDuino coin cell option Pins Used A5/SCL - I²C Clock A4/SDA - I²C Data Dimensions 17mm x 10mm (.670 inches x .394 inches) Max Height (from the lower bottom of Wireling to upper top Wireling Connector): 16mm (0.63 inches) Weight: 1 gram (.04 ounces) NOTES You can also use this Wireling without the TinyDuino – modifying the connecting cable by removing the opposite connector and stripping/tinning the wires, you can solder the connector cable to any other development board of your choice! DOWNLOADS SX1505 Datasheet SKRHABE010 Datasheet Schematic Eagle Files SX1505 Arduino Library Joystick Arduino Example Sketch CAD 3D and 2D Files
