This highly colorful, whimsical birdhouse is sure to get lots of attention wherever you display it! Hang this unique project from a tree limb using wire and an eyescrew or mount on a fence or tree trunk using our Flush Mount Hangers (available below). The bottom is hinged for easy clean out when nesting season is over. Fun project is easy to make from our full-size pattern and step-by-step instructions. (23" tall) Project uses two brass plated hinges (#BHNG1). More InfoDimensions: 22-9/16" tall x 19" wide Wood: One 1X12 x 72" long pine board One 2X4 x 5" long pine board Saw: Table Saw and Band Saw or Scroll Saw Supplies:Transfer paper (#CARB), pencil & clear tape Sand paper - medium & fine grits Wood glue - exterior (#GLUETB3) Wood filler - non-shrinking, fast drying for wood flaws Paint Brushes - 3/4", 1/4" and 2" wide brushes or foam tip Hardware:Required for displaying 1 - #BHNG1 - Brass Hinges 1 - #EYE3 - Eye Screw for hanging or 1 - #FMH - Flush Mount Hanger Paint:White primer (#PRIMQT) for a base coat and the following suggested colors of acrylic paint or exterior semi-gloss enamel: P2020 - Red Iron Oxide P2059 - Blue Jay P2090 - Hippo Grey P2505 - White P2506 - Black Sealer: High-grade, non-yellowing, semi-gloss UV protected project sealer (#POLYQT) for outdoor protection.
