Katool KT-AV533 3D Wheel Alignment Machine The Katool KT-AV533 is a 3D wheel alignment system designed for professional automotive service shops, using 3D imaging technology to capture wheel geometry without requiring traditional sensor-on-wheel hardware. The system performs front and rear axle alignment measurement for cars, light trucks, and SUVs. Measurable parameters include total toe, single wheel toe, camber, kingpin angle, thrust angle, and axis angle, covering the primary geometry checks performed during alignment service. The 3D imaging approach reduces setup time compared to conventional contact-sensor systems by eliminating per-wheel calibration before each cycle. The compact footprint suits installation in alignment bays without requiring large-format lift integration. Compatible applications include automotive repair shops, tire service centers, and alignment-focused bays. Installation, calibration, and operator training should follow Katool's commissioning procedures. .mm-feature-img{ display:block !important; width:100% !important; max-width:100% !important; height:auto !important; max-height:none !important; object-fit:contain !important; } Features Published Accuracy to ±2 Arc-Minutes Camber, single-wheel toe, thrust angle, and axis angle all measure to ±2 minutes, with total front toe and kingpin inclination at ±4' and ±6'. Display resolution is 1 arc-minute angular and 0.1 mm linear, and zero drift stays within 4 minutes over 30 minutes — so readings taken at the start of a job still hold at the end of it. ±2' camber and single-wheel toe 1' angular, 0.1 mm resolution Under 4' drift in 30 minutes Seven Alignment Angles Measured The system covers total front toe (±6°), single wheel toe (±3°), camber (±10°), kingpin rear angle (±15°), kingpin inclination (±20°), thrust angle (±6°), and axis angle (±6°). That's the full diagnostic picture for front and rear alignment service, not just the basic three, and the ranges are wide enough to catch damaged or badly out-of-spec vehicles. Seven measured angles Camber to ±10° Front and rear service 3D Imaging in a Compact Footprint Camera-based 3D imaging delivers those readings without the floor space a full alignment rack demands, which makes it workable in bays where space decides what equipment a shop can run. It suits repair shops, tire service centers, and alignment-focused bays adding capability without rebuilding the floor. Camera-based 3D imaging Compact footprint No alignment rack needed Specifications PRODUCT INFORMATION Model KT-AV533 Brand Katool Automotive Equipment Product Type 3D wheel alignment machine TOE MEASUREMENT Total Front Toe per Beam ±6° range, ±4′ accuracy Single Wheel Toe per Beam ±3° range, ±2′ accuracy CAMBER AND KINGPIN Wheel Camber ±10° range, ±2′ accuracy Kingpin Rear Angle ±15° range, ±2′ accuracy Kingpin Inclination ±20° range, ±6′ accuracy AXIS AND THRUST Thrust Angle ±6° range, ±2′ accuracy Axis Angle ±6° range, ±2′ accuracy PERFORMANCE Display Resolution 1′ angular, 0.1 mm linear Zero Drift 4′ or less within 30 minutes Indicating Value Error ±4′ What's Included 1× 3D alignment imaging cabinet (with cameras and beam assembly) 4× Wheel target plates with clamps 1× Workstation cabinet with PC and monitor Alignment software (preinstalled) Printer for alignment reports Calibration kit Power cables and signal cables Operator's manual and installation/calibration guide
