Krix Phoenix FloorStanding Speaker tonal depth, imaging and balanced musicality are highlights in this slim floorstanding design. Involve yourself in the experience of sound with the Phoenix Mk2. What's different in the Phoenix Mk2? The Phoenix Mk 2 has been redesigned from the ground up, to offer marked improvements in performance and a sleeker more contemporary appearance. The woofers’ magnetic size has increased by 50% and voice coil diameter increased from 25mm to 33mm to offer higher sensitivity, greater power handling and tighter more articulate bass. The tweeter has been replaced by the same ring radiating tweeter used in Krix’s flagship model, the Neuphonix, for added vocal warmth and smooth, revealing upper treble. The cabinet has also undergone a radical overhaul departing from Krix’s traditional ‘picture-frame’ style box construction in place of a new fully mitred construction technique creating a much cleaner aesthetic free from all visible panel joints. The new construction also results in less MDF wastage, utilising waste material to create an interlocking internal ‘X’ brace system for added box rigidity and internal standing wave suppression. The speaker box plinth has also been replaced by Krix proprietary rubber feet for improved acoustic isolation on hard and soft floor surfaces. Features: Power Handling: 50 – 200 Watts RMS Recommended Amplifier Power Impedance: Nominally 6 Ohms (min.3.5 Ohms) Dimensions: 955mm High x 195mm Wide x 310mm Deep Sensitivity: 91dB for 2.83 volts at 1 metre Feature Specification Frequency Range 35Hz-40kHz in room response Power Handling 50 – 200 Watts RMS recommended amplifier power Sensitivity 91dB for 2.83 volts at 1 metre Impedance Nominally 6 Ohms (minimum 3.5 Ohms) Configuration D’Appolito, 2-way Enclosure Type Bass reflex, rear vented with internal X bracing Low Frequency Drivers Dual nominal 165mm (6½”) laminated polypropylene cone. 33mm (1¼”) voice coil wound on high powered aluminium former, with ventilated spider and aluminium flux stabilization ring for low distortion High Frequency Driver 26mm (1″) dual concentric diaphragm with wave-guide centre plug for controlled directivity. Non-reflective dual chambered magnet structure with copper shorting ring to lower distortion Input Terminals Dual gold plated bi-wire binding posts (bi-wireable, bi-ampable) Dimensions 950mm high x 195mm wide x 295mm deep (including feet) Weight 18kg each
