Lanbao LAP - label sensor The Lanbao LAP is a label sensor built for label or gap detection in industrial automation equipment. Lanbao's official specification lists 3mm, NPN; PNP (based on current SKU options), 12...24VDC supply, and 2m 3 pins cable/25cm cable+M8 connector. This OpenELAB listing summarizes the product family for selectable SKUs, so always match the required output and connection against the variant name before ordering. For selection, confirm the sensing principle, range, output type, connection style, response time, protection rating, and accessory set against the exact SKU. Use the SKU code on the order page as the final reference for output polarity and cable style. If you are comparing nearby Lanbao models, also review Lanbao LAU, Lanbao UR18-CC15, and Lanbao UR18-CC35 so the housing style, measurement method, and control output match the machine input. Technical Specifications Parameter Value Model family LAP Sensor type label sensor Detection / measuring range 3mm Sensing method label or gap detection Output configuration NPN; PNP (based on current SKU options) Supply voltage 12...24VDC Response time ≤50us Light source Infrared light(940nm) Load / output current ≤10mA Connection 2m 3 pins cable/25cm cable+M8 connector Protection rating IP65 Material Zinc die casting; surface electroless nickel plating (Silver); PC plastic Operating temperature -20...60℃(No icing, no condensation) Indicator Red light: Calibration error / operation error; Green light: NO NC; Blue light: detect label switch output signal Board Layout & Label Guide Slot opening - Keep the active face clean and align it to the target path required by label or gap detection. Output indicator - Use the LED indication to confirm power, switching state, and any short-circuit or overload warning described by the official specification. Connection area - 2m 3 pins cable/25cm cable+M8 connector; route the cable or connector with strain relief before final commissioning. Supply input - Wire the sensor only within 12...24VDC; confirm polarity before applying power. Output selection - Match the selected SKU to this listing's output coverage: NPN; PNP (based on current SKU options). Adjustment / teach control - Use the controls described for the selected SKU; set the distance or threshold after the sensor is mounted in its final position. Mounting body - Use the listed accessory hardware and avoid mechanical stress on the lens, slot, or transducer surface. Protection rating - IP65; maintain sealing around the cable entry or connector during installation. Packing List 1 x Lanbao LAP sensor for the selected SKU Mounting hardware or accessories as supplied with the selected warehouse batch Product documentation and official specification reference Current store bundle contents may vary by SKU and warehouse batch FAQ Q: What is the main function of the Lanbao LAP?A: It is a label sensor for label or gap detection, with the range and output behavior defined by the selected SKU. Q: Which power supply should I use?A: Use 12...24VDC and confirm the sensor wiring before applying power. Q: Which output type should I order?A: Choose the SKU that matches the controller input. Current output coverage for this listing is: NPN; PNP (based on current SKU options). Q: Does the sensing distance always equal the rated value?A: Use 3mm as the official reference, then validate with the real target, mounting angle, and surface condition. Q: What should I check before commissioning?A: Check supply voltage, output wiring, target alignment, LED status, mounting stability, and the selected distance or teach setting. Q: Can I use it in wet or dusty equipment?A: The official protection rating is IP65. Keep the connector, cable outlet, and sensing face sealed as installed. Q: Is the product sold as all variants together?A: No. Select the required SKU from the store options; the title and description summarize the compatible product family. Q: Where should I verify final parameters?A: Use the official Lanbao specification page and the SKU shown on your OpenELAB order.
