Advance to a modern look.Customise your Transit with the all-new Autobeam LED Sequential Mirror Indicator Unit. During the indication process, the built-in bright amber LED lights flow from one side to the other in the desired signalling direction. The darkened glass enhances your exterior visually and gives your vehicle a more modern look. Simple fittingA simple Plug & Play design allows a quick installation of the LED indicators in the exterior of your vehicle. Features Advanced sequential technology Uniform distribution of light Long-Lasting/High Quality Plug & Play installation Direct replacement Error Free Low power consumption High lumen output Installation Remove the blind-spot mirrorPull the inner edge of the mirror glass towards the outer side of the vehicle.With fingers behind the glass, gently pull until the mirror detaches. Remove the main mirror glassPush the inner edge fully inwards, place fingers behind the outer edge, and carefully pull until the mirror releases. Remove the original indicator lensUndo the two T10 Torx screws and remove the indicator lens from the mirror housing. Remove the bulb holderTwist and remove the bulb holder from the original indicator and remove the bulb. Connect the new Autobeam indicator (bulb-dependent) W5W bulb: Plug the new indicator directly into the original vehicle plug W16W bulb: Use the supplied extension lead between the vehicle plug and the new indicator Seal the indicatorPush the rubber bung into the rear of the new indicator lens to prevent water ingress. Test before refittingTest the indicator operation before reinstalling the lens and mirror glass. Specification Voltage: 12vLight colour: AmberLens type: Smoked | Clear Fitment Ford Transit MK8.0 (2014-2020)Ford Transit MK8.5 (2020-2025) What's in the box 2x LED Sequential Indicator Units Warranty 3 Years If purchased outside the UK warranty is limited to 12 Months. Other Information Condensation may occur which is perfectly normal - These units have vents to accommodate normal changes in air pressure. Condensation can be a natural by-product of this design. When moist air enters the lamp assembly through the vents, there is a possibility that condensation can occur when the temperature is cold. When normal condensation occurs, a fine mist can form on the interior of the lens. The fine mist eventually clears and exits through the vents during normal operation. Models may vary, ensure fitment is correct for the vehicle before purchase. Packaging type may vary depending on stock and shipping restrictions.
