Link CAN Lambda Wideband Controller (CANLAM) - 125-1000 The Link CAN Lambda kit combines a Link CAN Lambda module with a genuine Bosch LSU4.9 wideband lambda sensor to give fast, accurate digital air-fuel ratio measurement over CAN bus. Designed and manufactured by LinkECU, it avoids the signal loss, electrical noise and calibration issues of analogue wideband controllers, and never needs free-air calibration. Suits: All Link G4+, G4X and G5 ECUs, plus other aftermarket ECUs that support the Link CAN Lambda protocol. Includes: CAN Lambda module, Bosch LSU4.9 sensor, Deutsch 4-way connector kit, O2 bung and plug, Link stickers, Quick Start Guide. Specifications Lambda measuring range: 0.67 to 10 CAN bit rates: 1 Mbit/s, 500 kbit/s, 250 kbit/s and 125 kbit/s Fully digital CAN communication, no free-air calibration required Operating voltage 6-23 V, maximum input voltage 37 V, maximum continuous current draw 3 A Connector: Deutsch 4-way connector kit; O2 bung and plug included Notes One CAN Lambda module is required for each wideband sensor. A compatible Link ECU supports up to eight modules. Modules are supplied pre-configured for a single-sensor installation. Link recommends installation and setup by an official Link dealer. The Bosch LSU4.9 sensor is sold for aftermarket use only. Bosch's warranty excludes aftermarket applications, so no warranty is provided on the sensor. You may also need For a Link G4+ or G4X Plug-in ECU, you need a CANPCB cable (101-0022) and a CANF field-installable CAN plug (101-0020) to reach the ECU's CAN port. Downloads CAN Lambda User Manual (PDF) CAN Lambda Quick Start Guide (PDF)
