Easy to install. Affordable. Reliable. G4X PlugIn ECUs offer the latest in engine management technology, designed to easily maximize the potential from your car. This ECU fits inside the factory OEM enclosure. Installation of the processing unit is a breeze, with no alteration of the factory wiring loom required for the models listed below. Designed for the Honda S2000 AP1. Please check your connector matches the header in the listed photo before purchasing. This ECU works for manual transmissions only. This ECU doesn't support factory E-Throttle Models Most factory features are supported. Check the features tab for I/O input & output expansion options Note: This Plug-in features a new 4 pin powered CAN connector and cannot use the old CANPCB cable for CAN connection. Use the CANJST4 (Code 101-0198) cable for connecting CAN devices. This new 4 pin port and cable provide not only the CAN connection, but also a protected 12V power supply and ground for powering the CAN devices. The power supply is protected by a self-resetting fuse rated at 3A continuous. Suitable applications for 233-4000 automotive computer unit: Honda S2000 AP1 1999-2004 Honda S2000 AP2 2005 (Non E-throttle) G4X PlugIn Key Features (where applicable):Up to 6D fuel and ignition mappingPrecision closed loop cam control (four cam, independent control)Sequential fuel deliveryDigital triggering, all OEM patternsOEM idle hardware supported5D boost control with three switchable tablesMotorsport features - antilag, launch, flat shiftContinuous barometric correction (on board)CAN portQuickTune - automated fuel tuningIndividual cylinder correctionUSB tuning cable includedStats recording into on-board memoryGear compensations for spark, boost and fuelReal time selectable dual fuel, ignition and boost mapsSync and crank sensors can be a combination of Hall effect, variable reluctance or opticalBoost control referenced to gear, speed or throttle position512 mega bytes data logging memory within data processing unitStaged injectionKnock with "windowing"I/O Expansion Options:The following expansion connector inputs/outputs are provided: E-Throttle ConnectorE-Throttle 1 - Ground (Signal)E-Throttle 2 - +5V OutE-Throttle 3 - An Volt 10E-Throttle 4 - An Volt 9E-Throttle 5 - An Volt 8E-Throttle 6 - An Volt 7E-Throttle 7 - Aux 10E-Throttle 8 - Aux 9Expansion Connector 1 Expansion 1 - Ground (Signal) Expansion 2 - Aux 11 Expansion 3 - Aux 6 Expansion 4 - DI 11 Expansion 5 - DI 10 Expansion 6 - DI 9 Expansion 7 - DI 2 Expansion 8 - DI 1 Expansion Connector 2 Expansion 9 - Ground (Signal) Expansion 10 - Aux 16 Expansion 11 - Not Connected Expansion 12 - Not Connected Expansion 13 - Not Connected Expansion 14 - Not Connected Expansion 15 - An Volt 12 Expansion 16 - An Volt 6
