The FB Series is used to monitor the operation of one twolamp incandescent beacon and one beacon flasher (or auxiliary module). The flasher and lamps are monitored by sensing the flow of current in the circuit. If the lamp(s) or the flasher fail to operate properly, a solid-state output and an isolated SPDT relay energize. When connected to a site monitoring system, this unit provides the remote beacon monitoring protection required by the FAA/FCC. On a multiple beacon structure, one unit is required for each two-lamp incandescent beacon (one unit per beacon for LED beacons). Operation If one lamp in an incandescent beacon fails, the relay and solidstate lamp failure outputs energize after 10s. If the flasher fails in the ON or OFF condition, the relay and the solid-state flasher failure output energizes after 6s. If both failures occur, all three outputs energize after their trip delays. Note: If both incandescent lamps fail, all three outputs will energize. The relay and solid-state flasher failure output energizes after 6s, and the solid-state lamp failure output energizes after 10s. Pre-order 6-8 Weeks Input Voltage FB230A :230VAC ±15% AC Line Frequency 50/60Hz Lamp Socket Voltage ±10%; 50/60Hz Alarm Outputs Type 3 total - 1 relay, 2 solid state;One isolated SPDT relay rated 5A resistiveTwo solid-state line voltage outputs rated0.5A steady, 5A inrush Lamp Failure Detection FB230A For two 500W or 700W lamps Trip Delays Flasher Failure Fixed at 6s; -0/+40% Lamp Failure Fixed at 10s; -0/+40% LEDs Lamp Failure (Red) Glows when one or both lamps fail Flasher Failure (Red) Glows when the flasher fails Protection Circuitry Encapsulated Mounting Surface mount with two #6 (M3.5 x 0.6) screws Dimensions H 88.9 mm (3.5”); W 63.5 mm (2.5”);D 44.5 mm (1.75”) Termination 7 position barrier block for 20 AWG (0.5 mm2 ) to 14 AWG (2.5 mm2 ) wire Environmental Operating/Storage Temperature -55° to 60°C / -55° to 85°C Weight ≅ 7 oz (198 g)
