Looking to give your Litter-Robot a bit of a refresh? This is the ideal pack to refresh the metal components, seals and filter. Pinch Detectors Replacement anti-pinch pins, or Pinch Detectors, for Litter-Robot III Open Air Installation Base and Bonnet Connectors Bonnet and Base Connectors are located to the left side of the Litter-Robot and provide power flow from base to bonnet (night light) and back again. With use, you may find that you need to replace these consumable metal parts, if they get scratched and worn, or have corrosion or carbon deposits on them that interrupt good power flow. Bonnet Connectors Visible left side of bonnet when bonnet is removed. 2 screws hold the cover sleeve in place. Unscrew, lift off, and you can access the 2 metal connectors. Lift out of track, remove from the plug (do not pull the wire, hold the plug) and push in replacement. Do make sure the purple and black wires are still in the same position as the power flow will be affected if reversed. Refit sleeve. Base Connectors The Base Connectors are located to the left side shoulder of the base. To access these for replacement, the base needs to be turned upside down and 9 screws removed. The base can then be lifted apart into 2 halves, to access the base connectors. Unplug and replace the connectors, making sure the purple and black wires are in the same orientation. Refit the base halves together, and replace screws. Carbon Filter and Seal Strips Carbon Filter Litter-Robot 3 is equipped with a carbon filter for absorbing odors and controlling moisture in the waste drawer. The flexible filter pad can be removed and replaced when cleaning the drawer. View installation video Seal Strips Litter-Robot 3 is equipped with brush-type seal strips that sit on the base under the globe and help contain odor within the waste drawer. Download installation guide
