The Benwil 300397 lock release component is the direct replacement for the Benwil lift it came off of. Cross-referenced as ALS-7208-09, it is the genuine Benwil part — same part number, same fit, and same working specification as the one already on your lift. Ordering the Benwil lock release component from us gets you the OEM piece that matches the lift, not an aftermarket knock-off that is close but not the same. Specifications Part number: ALS-7208-09 Brand: Benwil Type: Genuine OEM lock release component The lock release cable on a 2-post lift is the small cable that runs from the release handle on the pump-side column, up and over the overhead beam (through slide blocks or pulleys), and back down the far column to pull that far column's lock pawl. Pull the handle, both pawls release, and the lift can come down. When this cable frays, breaks, or stretches so much that pulling the handle no longer releases the far pawl, the lift will only lower on one side and hang up on the locks on the other side. Related parts for this lift The parts below are commonly ordered alongside this one — cables, sheaves, seals, and hardware wear on similar schedules, and most repairs go faster when the whole set is done in one visit. Latch Assy-GPOA7 - Benwil - 300840 Handle Latch Actuator - Benwil - 300843 Spacer for Latch - Benwil - 500728 Latch Bracket - Benwil - 500723 Confirm this is the right part before you order Lift manufacturers revise parts mid-production without changing the model name, so the same lift bought two years apart can take two different revisions of the same component. Before you order, find the model plate on the lift — on most 2-post lifts it rides on one of the columns at eye level, on 4-post lifts it is usually on a column or the power-unit side runway — and note the full model number and serial. The serial dates the lift to a production run, and that is what decides which revision fits. If the plate is painted over or missing, take a photo of the part you are replacing next to a tape measure and send it to us. Between the dimensions, the mounting pattern, and what lift it came off of, we can almost always identify the exact part before you spend money on the wrong one. Also check Both lock pawls — broken, chipped, rusted, or with rounded engagement faces The pulleys or slide blocks the cable rides on — deep grooves worn in the plastic The clamp at each cable end — still intact, not slipping Return spring on the far-side pawl — a weak return spring means the pawl does not re-engage after release Confirm both locks engage before putting a vehicle on the lift. A lift that only locks on one side is a lift that drops one side under load. Why buy your Benwil lock release component from Auto Lift Services We install, inspect, and repair Benwil lifts every week — the ALS-7208-09 is a part we handle in the shop, not a random SKU we drop-ship. The phone answers if you have a question mid-install — call 800-674-9302. We confirm the right part for your lift's serial and production year before you order. Every part ships as genuine Benwil — no aftermarket substitution unless you specifically ask for an aftermarket equivalent. If you also need companion wear items — cables, sheaves, seals, hardware — for the same repair, use our parts lookup and we will build the whole kit for your lift so you order once and finish the job.
