IMPORTANT: A running change has been made to the Wahoo Elemnt Bolt V2 device that means there are now two versions of tether. The version you require can be determined from either the serial number or a visual check of the tether recess on the back of the device. MagCAD Wahoo Elemnt Bolt V2 Tether MagCAD Wahoo Elemnt Bolt V2.1 Tether Model: WFCC5 V2 Model: WFCC5 V2 Manufactured before July 2024 Manufactured after July 2024 Serial Number: < 43242600001 Serial Number: > 43242600001 Please contact us if you are unsure; share a quick photo of the back of your Wahoo device with tether recess and serial number and we will confirm. What's Included 1x 3D printed anchor. 1x adjustable lanyard. 1x M2 x 6mm countersunk screw. The Wahoo devices pictured are for reference only and not included. Overview A tether for the Wahoo Elemnt Bolt (V2) computers. Attaches to the recess on the back of your device with the M2 screw (provided). The lanyard can then be secured to your handlebars before each ride, reducing the risk of accidently dropping your device. This tether is designed specifically for the Bolt (V2), launched in May 2021, featuring a colour screen and slightly larger size. This V2 tether is for devices manufactured before July 2024 and serial numbers preceding 43242600001. See our MagCAD Wahoo Elemnt Bolt V2.1 Tether for Bolt V2 devices with serial numbers following 43242600001. See our MagCAD Wahoo Elemnt Tether - Bolt (V1) and Roam (V1) for the original Bolt (V1) and Roam (V1) with black and white screen. See our MagCAD Wahoo Elemnt Roam V2 Tether for the Roam (V2) which is a larger device and has a colour screen. Application Fitting the tether is a simple process: Clean any dirt or debris out from the tether recess on the back of your device. Push the 3D printed tether block into the recess on the back of your device. The block should be a tight fit and sit flush with the back face of the device. Secure the 3D printed tether block with the countersunk M2 screw, supplied. A Pozidrive screwdriver should be used to install the screw. Using a Philips (cross head) screwdriver risks rounding the screw head. Ensure the screw sits flush with the 3D printed tether block and avoid overtightening. NOTE: The first time you install a tether into your Wahoo device the screw will cut a thread into the plastic hole. Therefore, you should apply some forward pressure at the same time as rotating the screw to allow the new thread to be cut. If the screw doesn't finish flush; remove it, clear out the hole and reinstall. Before each ride loop the lanyard around your handlebars and install the computer onto its mount. The adjuster gives you an alternative way of securing to your bike as well as a way of keeping the cords tidy. The lanyard is approx. 200mm in total length; long enough to suit the majority of installations without having lots of extra length on display. If you have particularly wide aero handlebars the tether may not be long enough to loop around the bar in the normal way. But it should be possible to attach it to something else like a cable or computer mount as an alternative. Compatible With: Wahoo Elemnt devices; Bolt (V2), manufactured before July 2024 and with serial numbers preceding 43242600001. Specifications Weight: 4 grams (without hardware). Disclaimer This product and/or service is not affiliated with, endorsed by or in any way associated with Wahoo Fitness LLC or their products and services. Wahoo and their respective logos are trademarks or registered trademarks of Wahoo Fitness LLC.
