Are you looking to buy a Matek CAN-L4-3100 Dronecan Magnetometer in Australia? Features CAN-L4-3100 is a professional grade CAN Magnetometer based on RM3100 & ArudPilot AP_Periph firmware. RM3100 sensor technology provides high resolution, low power consumption, large signal noise immunity, a large dynamic range, and high sampling rates. Measurements are stable over temperature and inherently free from offset drift. Specifications PNI RM3100 Geomagnetic Sensor CAN node MCU: STM32L431xC, 256KB Flash Interface CAN, DroneCAN Protocol UART2, MSP output (MatekL431-Periph fw) UART3, for external GNSS module ST debug, SWCLK & SWDIO LED Blue, Fast blinking, Booting Blue, Slow blinking, working Red, 3.3V indicator Power supply for CAN-L4-3100 board : 4.5~5.5V @5V pad/pin Power consumption: 22mA Operating Temperatures: -40~85 °C Physical Board Size: 36mm*25mm*10mm. 6g 3D File CAN-L4-3100_step.zip Firmware ArduPilot AP_Periph: MatekL431-GPS or MatekL431-Periph Update via DroneCAN GUI Tool or Mission Planner (AP_Periph.bin) Update via STLink (AP_Periph_with_bl.hex) Parameters CAN_P1_DRIVER = 1 if attached to CAN bus1 port or CAN_P2_DRIVER = 1 if attached to CAN bus2 port COMPASS_AUTODEC = 1 Important Information CAN-L4-3100 is pre-installed with “MatekL431-GPS” firmware. MSP feature is disabled in “MatekL431-GPS”. If you want to use MSP feature, reflash it with “MatekL431-Periph” firmware(AP_Periph_with_bl.hex) over SWC/SWD pads via ST-LINK. Put magnetometer far from power lines/ESC/motors/iron based material. >=10cm 2 ears for mounting can be cut off if you don’t need it. If the CAN wires are too long, bridge the “120R” jumper. Included 1x CAN-L4-3100 board 1x JST-GH-4P to JST-GH-4P 20cm silicon wire Browse more Browse all GPS Browse all Matek
