✦ Verified product
Matek H7A3-WING Flight Controller
AUD 119.80
Phaser FPV
Verified independent store
→
Specifications MCU: STM32H7A3RIT6, 280MHz Cortex-M7, 1.4MB RAM, 2MB Flash IMU: ICM42688P Baro: SPL06-001 OSD: AT7456E Blackbox: MicroSD socket I2C digital power monitor 6x Uarts (1
,2,3,4, 5, 6) with built-in inversion. 11x PWM outputs 1x I2C 1x CAN 4x ADC (VBAT, Current, VB2, Cur2) 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red) USB/Beep Extender with Type-C(USB2.0) 2x JST-GH1.25_4pin connector for CAN and I2C 9V/12V output ON/OFF switchable Digital video OSD is supported by any spare UART Regulators Vbat Input: 9~30V (3~6S LiPo) BEC 5V/4v5: 2.5A cont. /3A peak BEC 9V/12V: 2A cont. /3A peak BEC Vx: 8A cont. /12A Peak, output 5V Default, 6V or 7.2V option. LDO 3.3V: Max.200mA 12C Digital Power Monitor No calibration required. Current sensing resistor: 0.00025 ohm Load current on current sensing resistor: 100A(Continuous), 164A(Burst) Voltage accuracy: ± 0.1% Current accuracy: ± 2% INA2xx I2C address: 0x45 (69) Parameters BATT_MONITOR ->21 (INA2xx) BATT_SHUNT -> 0.00025 BATT_MAX_AMPS -> 164 BATT_I2C_BUS -> 0 default BATT_I2C_ADDR -> 0 default (or 69) FC Firmware ArduPilot: MATEKH7A3 (4.6 or newer) ArduPlane https://firmware.ardupilot.org/Plane/beta/MatekH7A3/ ArduCopter https://firmware.ardupilot.org/Copter/beta/MatekH7A3/ Flashing with STM32CubeProgrammer Physical Mounting: 30.5 x 30.5mm, Φ4mm with Grommets Φ3mm Dimensions: 54 x 36 x 13 mm Weight: 30g with USB extender Includes 1x H7A3-WING 1x USB(Type-C)/Beep (Passive buzzer) Extender with 6pin cable 1x 20cm JST-SH-6P to JST-SH-6P cable for USB extender. 2x 20cm JST-GH-4P to JST-GH-4P cable for CAN & I2C port 1x Rubycon ZLH 35V 470uF capacitor Dupont 2.54 pins (Board is shipped unsoldered) Browse more Browse all Matek Flight Controllers Browse all Wing Flight Controllers Browse all F4 Flight Controllers
